R&S®ZVA Vector Network Analyzers - Media Center

Level-controlled passive intermodulation (PIM) measurements presented at EuMW 2013

Rohde & Schwarz demonstrated fast and accurate passive intermodulation (PIM) testing of duplex filters at the European Microwave Week 2013 in Nuremberg.

Simplified test setup using R&S®ZVAB-K30 noise figure measurement option

This video demonstrates the simple and straight-forward calibration steps including power calibration of source and receivers, noise figure calibration and system error correction, and the noise figure measurement.

Satellite measurements without LO access presented at EuMW 2013

Rohde & Schwarz presented group delay measurements on converters without LO access at the European Microwave Week 2013 in Nuremberg.

Millimeter wave measurements in one sweep with the R&S®ZVA110 presented at EuMW 2012

Rohde & Schwarz presented the R&S®ZVA110 vector network analyzer at the European Microwave Week 2012 in Amsterdam.

Group delay measurement on devices with embedded LO using option R&S ZVA-K9

This video demonstrates group delay and relative phase measurements on frequency converting devices where access to the LO is limited.

Signal integrity – calibrating a 4-port network analyzer (part 1 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring rise time using a true differential signal (part 2 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring differential impedance vs. distance (part 3 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring time domain skew between two lines on a differential transmission (part 4 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.