When Rohde & Schwarz meets research - a success story!

November 25, 2022 | by Marco Neri

Read the interview with Özgü Alay, PhD, Associate Professor at the University of Oslo, and Giuseppe Caso, Experienced Researcher at Ericsson Research, Stockholm, about the 2020 measurements of commercial 5G networks in Italy.

Read more

5G mobile network testing using a passive network scanner (Part 4)

November 1, 2022 | by Corbett Rowell

Network Synchronization of 5G networks

The last blog post (Part 3) examined the first challenge of how you can measure and analyze 5G networks passively by analyzing synchronization and broadcast signals. In this article we address the challenge of timing alignment between 5G base stations as this has a large effect on inter-cell interference and consequently user experience.

Read more

Interactivity test: Packet delay variation and packet loss (part 6)

October 17, 2022 | by Jens Berger

Data transport latency has become a very – if not the most – important factor in interactive and real-time use cases for next generation mobile networks. Real-time capability is not determined by the average latency at which the packets are delivered, but rather by the latency of the slowest packets. The following analyzes delay jitter and the packet loss in the uplink and downlink.

Read more

5G mobile network testing using a passive network scanner (Part 3)

September 9, 2022 | by Corbett Rowell

How to measure 5G networks?

The last blog post (Part 2) explained the technical background and the setup of the measurements in FR1 and FR2. In this article we discuss how you can measure and analyze 5G networks passively by analyzing synchronization and broadcast signals.

Read more

5G NR and LTE latency analysis in a public network (part 1)

August 29, 2022 | by Meik Kottkamp

This article provides measurements results for both one-way latency (OWL) and round-trip times (RTT) in a commercially deployed, public 5G NSA network obtained using the commercially available Interactivity Test based on the QualiPoc Android solution for RTT from Rohde & Schwarz (prototype for OWL).

Read more

5G mobile network testing using a passive network scanner (Part 2)

August 8, 2022 | by Corbett Rowell

Technical Background and Measurement Setup

In the previous introductory blog post: 5G mobile network testing using a passive network scanner (Part 1), we discussed why a dedicated scanner is necessary for accurate mobile network testing. This post explains the technical background and the setup of the measurements in FR1 and FR2.

Read more

Coverage and performance testing of 5G private networks

July 8, 2022 | by Gregor Tomic

Private networks are becoming more important in various industries that, however, still seems to be in the trial phase with 5G and various use cases. Our experience with recent measurement campaigns shows that we still have a long way to go to meet the targets for latency and throughput in high traffic networks. Read our story to get more information about how to test the quality of private 5G networks.

Read more

5G mobile network testing using a passive network scanner (Part 1)

June 23, 2022 | by Corbett Rowell

Introduction

This new blog series emphasizes the importance of passive mobile network testing for the technology and deployment verification of 5G NR in the field and its future development. This introduction covers the main topics that will be detailed in later posts of this series.

Read more

Dimensioning a mobile network benchmarking campaign

May 12, 2022 | by Nils Posegga

The Network Performance Score is used to benchmark networks against competitors over time and even across country boundaries. Rohde & Schwarz implementation in line with ETSI TR 103559 provides the tools needed for data collection and post processing. But what does the dimensioning of a campaign look like when it has representative and statistically reliable results?

Read more

5G site testing and troubleshooting mobile networks

March 21, 2022 | by Peter Busch

Commercial 5G rollout is happening now and more and more 5G non-standalone (NSA) sites are being deployed. Existing LTE infrastructure is being converted into dynamic spectrum sharing (DSS) hybrid sites supporting 5G. An increasing number of private regional 5G networks in standalone (SA) mode are going into trial phase.

Read more

Interactivity test: Impact of changing network conditions on latency and jitter (part 5)

February 17, 2022 | by Jens Berger

Data transport latency has become a very – if not the most – important factor in interactive and real-time use cases for next-generation mobile networks. Real-time capability is not determined by how fast the packets are delivered but by which ones are received last. The following analyzes the distance data packets have to travel in mobile network channels when network conditions change.

Read more

Testing can make Open RAN a success

January 31, 2022 | by Magnus Hylén

The biggest challenges the industry faces with Open RAN include the interoperability of different elements from different vendors and generating performance levels similar to those of single vendor networks. Extensive testing can help overcome these challenges.

Read more

Benchmarking & optimization

More information

Field services & interference hunting

More information

Innovations in mobile network testing

More information

Testing from RF to QoE

More information

New e-book provides unparalleled insight into the 5G NR world

What's the status of 5G NR? What are the test and measurement requirements, and how do we approach them? Download our new e-book now and get unparalleled insight into the world of 5G NR.

More information

The world's first 5G NR network measurement solution

Rohde & Schwarz is pioneering 5G New Radio (5G NR) network measurements with the world's first commercially available 5G NR network measurement solution. This solution enables users in the 5G network ecosystem as well as regulators to measure the 5G NR network coverage accurately - one of the biggest challenges in the network planning.

More information

Pioneers in NB-IoT field measurements

We are paving the way to NB-IoT by provding the world's first accurate LTE/NB-IoT coverage measurement solution: via a software upgrade, the R&S ROMES drive test software now also supports NB-IoT coverage measurements with R&S TSMx scanners.

More information